Artificial Grass Products :: SYNBermuda Platinum 300

SYNLawn Synthetic Grass Product: SYNBermuda Platinum 300

SYNBermuda Platinum 300

Price: Call for price

Warranty: 12 year warranty

Face weight: 60 ounces

Total weight: 87 ounces

* Prices reflect product only and do not include installation costs. For installation costs contact your local SYNLawn.

SYNBermuda Platinum 300

SYNBermuda Platinum 300 takes the ultra-resilient construction of the SYNBermuda collection and adds SYNLawn’s HeatBlock Techonology™ to reduce the impact of the heat causing rays from the sun. This added technology in the yarn reduces the surface temperature almost 20% while still providing superior performance for high demanding applications like pet kennels, school playgrounds and high traffic commercial common areas.

Environment Friendly
Exclusive EnviroLoc technology with BioCel backing system results in 60%-70% green by weight with greater dimensional stability. Contributes points towards LEED certification.
Anitmicrobial Protection
AlphaSan® antimicrobial technology to prevent growth of harmful bacteria designed for playground and pet applications.
No infill required
No black rubber crumb necessary. Greatly reduces maintenance of artificial turf.
Resiliency
Superior resiliency with 100% nylon fibers.
Recommended for
Residential landscapes, sloped areas, water saturated areas, pool areas and moderate to high traffic areas. Highly recommended for child play areas and pet areas.
Yarn type
  • Grass Zone: EPN Nylon
  • Thatch Zone: High Bulk Texturized Nylon
Color
  • Grass Zone: Turf Green
  • Thatch Zone: Turf Green
Pile height
  • Grass Zone: 1.25"
  • Thatch Zone: 1"
Face weight
60 ounces
Total weight
87 ounces
Warranty
12 year warranty year
Roll width
15.00 Feet
Drain rate
60 inches per hour
Sub-base
  1. Remove sod if necessary.
  2. Grade must be at least 3 inches below the border (curbing, edging, patio, etc.).
  3. Install at least 2-4 inches of 1/4" minus compaction aggregate (road base) bringing the grade up to 1 inch below the border.
  4. Level and disperse aggregate with landscape rake.
  5. Lightly soak the aggregate.
  6. Compact aggregate using a vibratory plate compactor. Aggregate may be added to low areas during this process.

Note: Aggregate will stick to the compactor if too wet. At least 80% compaction is ideal.

Seams
  1. Precisely cut the edge against the tufted row.
  2. When seams are in position, place a nail approximately 18 inches from the seam to secure the turf.
  3. Fold back the turf and hold with a temporary weight.
  4. Lay 12-18 inch urethane cloth directly under the seam.
  5. Secure cloth with a nail at the end of the seams.
  6. Pour and spread adhesive on the cloth. (use scrap piece to spread adhesive) Remove the weight from the folds.
  7. Slowly and simultaneously lay both sides of the turf on the adhesive. Avoid overlapping the backing. In addition, make sure the fibers do not come in contact with the adhesive.
  8. Apply weight on the seams and allow 1hour to dry. When complete, seams may be reinforced with nails.
Edges
  1. Overlap edges with turf.
  2. Secure the position of the turf with nails.
  3. As with seaming, fold back turf to the edge exposing the backside.
  4. Cut vertical relief cuts to create smaller sections to work with. On the backside, cut the excess turf precisely to the edge. Turf should be cut within 1/8 inch from the edge.
Infill
Infill not required.