Artificial Grass Products :: SYNBlue Premium 200

SYNLawn Synthetic Grass Product: SYNBlue Premium 200

SYNBlue Premium 200

Price: Call for price

Warranty: 10 year warranty

Total weight: 83 ounces

* Prices reflect product only and do not include installation costs. For installation costs contact your local SYNLawn.

SYNBlue Premium 200

Simply the most durable, versatile synthetic grass on the market. With 83 ounces of 100% nylon, SYNBlue Premium 200 is an excellent artificial grass product for areas of high foot traffic. When it was first produced this product was the first non-infill artificial turf.

Environment Friendly
Exclusive EnviroLoc technology with BioCel backing system results in 60%-70% green by weight with greater dimensional stability. Contributes points towards LEED certification.
No infill required
No black rubber crumb necessary. Greatly reduces maintenance of artificial turf.
Resiliency
Superior resiliency with 100% nylon fibers.
Recommended for
Commercial landscapes, sloped areas, water saturated areas, pool areas and high traffic areas. Highly recommended for child play areas and pet areas.
Yarn type
  • Grass Zone: Nylon
  • Thatch Zone: High Bulk Texturized Nylon
Color
  • Grass Zone: Turf Green
  • Thatch Zone: Turf Green
Pile height
  • Grass Zone: 1.75"
  • Thatch Zone: 1.5"
Total weight
83 ounces
Warranty
10 year warranty year
Roll width
15.00 Feet
Drain rate
30 inches per hour
Sub-base
  1. Remove sod if necessary.
  2. Grade must be at least 3 inches below the border (curbing, edging, patio, etc.).
  3. Install at least 2-4 inches of 1/4" minus compaction aggregate (road base) bringing the grade up to 1 inch below the border.
  4. Level and disperse aggregate with landscape rake.
  5. Lightly soak the aggregate.
  6. Compact aggregate using a vibratory plate compactor. Aggregate may be added to low areas during this process.

Note: Aggregate will stick to the compactor if too wet. At least 80% compaction is ideal.

Seams
  1. Precisely cut the edge against the tufted row.
  2. When seams are in position, place a nail approximately 18 inches from the seam to secure the turf.
  3. Fold back the turf and hold with a temporary weight.
  4. Lay 12-18 inch urethane cloth directly under the seam.
  5. Secure cloth with a nail at the end of the seams.
  6. Pour and spread adhesive on the cloth. (use scrap piece to spread adhesive) Remove the weight from the folds.
  7. Slowly and simultaneously lay both sides of the turf on the adhesive. Avoid overlapping the backing. In addition, make sure the fibers do not come in contact with the adhesive.
  8. Apply weight on the seams and allow 1hour to dry. When complete, seams may be reinforced with nails.
Edges
  1. Overlap edges with turf.
  2. Secure the position of the turf with nails.
  3. As with seaming, fold back turf to the edge exposing the backside.
  4. Cut vertical relief cuts to create smaller sections to work with. On the backside, cut the excess turf precisely to the edge. Turf should be cut within 1/8 inch from the edge.
Infill
Infill not required.