Artificial Grass Products :: SYNFescue Platinum 320

SYNLawn Synthetic Grass Product: SYNFescue Platinum 320

SYNFescue Platinum 320

Price: Call for price

Warranty: 9 year warranty

Total weight: 105 ounces

* Prices reflect product only and do not include installation costs. For installation costs contact your local SYNLawn.

SYNFescue Platinum 320

SYNFescue Platinum 320 is the top of the line multi-colored artificial grass product with an incredible natural looking appearance. Made with a face weight over 80 ounces this synthetic grass product will perform under just about any condition. Heavy commercial foot traffic, dog runs and school yards are typical applications for this heavyweight.

Environment Friendly
Exclusive EnviroLoc technology with BioCel backing system results in 60%-70% green by weight with greater dimensional stability. Contributes points towards LEED certification.
No Infill
No black rubber crumb necessary. Greatly reduces maintenance of artificial turf.
Resiliency
Nylon thatch for resiliency and support combined with polyethylene monofilament long blades for soft feel.
Recommended for
Residential and commercial landscapes, child play areas, pet areas, pool areas, water saturated areas, problem areas and shady areas. Recommended for lawns with high foot traffic.
Yarn type
  • Grass Zone: Polyethylene
  • Thatch Zone:Texturized High Bulk Nylon
Color
  • Grass Zone: Field Green
  • Thatch Zone: Verde
Pile height
  • Grass Zone: 2"
  • Thatch Zone: 1.75"
Total weight
105 ounces
Warranty
9 year warranty year
Roll width
15.00 Feet
Drain rate
30 inches per hour
Sub-base
  1. Remove sod if necessary.
  2. Grade must be at least 3 inches below the border (curbing, edging, patio, etc.).
  3. Install at least 2-4 inches of 1/4" minus compaction aggregate (road base) bringing the grade up to 1 inch below the border.
  4. Level and disperse aggregate with landscape rake.
  5. Lightly soak the aggregate.
  6. Compact aggregate using a vibratory plate compactor. Aggregate may be added to low areas during this process.

Note: Aggregate will stick to the compactor if too wet. At least 80% compaction is ideal.

Seams
  1. Precisely cut the edge against the tufted row.
  2. When seams are in position, place a nail approximately 18 inches from the seam to secure the turf.
  3. Fold back the turf and hold with a temporary weight.
  4. Lay 12-18 inch urethane cloth directly under the seam.
  5. Secure cloth with a nail at the end of the seams.
  6. Pour and spread adhesive on the cloth. (use scrap piece to spread adhesive) Remove the weight from the folds.
  7. Slowly and simultaneously lay both sides of the turf on the adhesive. Avoid overlapping the backing. In addition, make sure the fibers do not come in contact with the adhesive.
  8. Apply weight on the seams and allow 1hour to dry. When complete, seams may be reinforced with nails.
Edges
  1. Overlap edges with turf.
  2. Secure the position of the turf with nails.
  3. As with seaming, fold back turf to the edge exposing the backside.
  4. Cut vertical relief cuts to create smaller sections to work with. On the backside, cut the excess turf precisely to the edge. Turf should be cut within 1/8 inch from the edge.
Infill
Infill not required.