Artificial Grass Products :: SYNRye 100

SYNRye 100

Price: Call for price

Warranty: 8 year warranty

Total weight: 67 ounces

* Prices reflect product only and do not include installation costs. For installation costs contact your local SYNLawn.

SYNRye 100

SYNRye 100 is constructed with highly texturized nylon fibers in the Thatch Zone creating a tight low-profile random pattern. This artificial turf product is made with 100% nylon fibers resulting in a highly durable grass product for high traffic often used for child play areas and dog runs.

Features
Product Specs
Installation Specs

Environment Friendly: Exclusive EnviroLoc technology with BioCel backing system results in 60%-70% green by weight with greater dimensional stability. Contributes points towards LEED certification.
No infill required: No black rubber crumb necessary. Greatly reduces maintenance of artificial turf.
Resiliency: Superior resiliency with 100% nylon fibers.
Recommended for: Residential landscapes, sloped areas, water saturated areas, pool areas and moderate to high traffic areas. Highly recommended for child play areas and pet areas.

Yarn type

Grass Zone: Nylon
Thatch Zone: High Bulk Texturized Nylon

Color

Grass Zone: Turf Green
Thatch Zone: Tan

Pile height

Grass Zone: 1.625"
Thatch Zone: 1.125"

Total weight

67 ounces

Warranty

8 year warranty year

Roll width

15.00 Feet

Drain rate

30 inches per hour

Sub-base

Remove sod if necessary.
Grade must be at least 3 inches below the border (curbing, edging, patio, etc.).
Install at least 2-4 inches of 1/4" minus compaction aggregate (road base) bringing the grade up to 1 inch below the border.
Level and disperse aggregate with landscape rake.
Lightly soak the aggregate.
Compact aggregate using a vibratory plate compactor. Aggregate may be added to low areas during this process.

Note: Aggregate will stick to the compactor if too wet. At least 80% compaction is ideal.

Seams

Precisely cut the edge against the tufted row.
When seams are in position, place a nail approximately 18 inches from the seam to secure the turf.
Fold back the turf and hold with a temporary weight.
Lay 12-18 inch urethane cloth directly under the seam.
Secure cloth with a nail at the end of the seams.
Pour and spread adhesive on the cloth. (use scrap piece to spread adhesive) Remove the weight from the folds.
Slowly and simultaneously lay both sides of the turf on the adhesive. Avoid overlapping the backing. In addition, make sure the fibers do not come in contact with the adhesive.
Apply weight on the seams and allow 1hour to dry. When complete, seams may be reinforced with nails.

Edges

Overlap edges with turf.
Secure the position of the turf with nails.
As with seaming, fold back turf to the edge exposing the backside.
Cut vertical relief cuts to create smaller sections to work with. On the backside, cut the excess turf precisely to the edge. Turf should be cut within 1/8 inch from the edge.

Infill